hesitation on bottle, plugs?
hesitation on bottle, plugs? the previous owner of my car ran a 150 wet shot.
When I got the car, I put a 100shot nx wet kit, brand new everything on. The car seems to hesitate a little on the bottle, runs fine NA. Is this a plug issue? Maybe need colder plug?
I thought it was a fueling issue, but walbro pump and hotwire kit later, its still there.
I don't notice it with a 1 or 2 second hit...its when im im spraying through an entire gear or 2 and stay in it.
When I got the car, I put a 100shot nx wet kit, brand new everything on. The car seems to hesitate a little on the bottle, runs fine NA. Is this a plug issue? Maybe need colder plug?
I thought it was a fueling issue, but walbro pump and hotwire kit later, its still there.
I don't notice it with a 1 or 2 second hit...its when im im spraying through an entire gear or 2 and stay in it.
No timing pulled/tuning for nos.
I dunno what's in the motor now. If they are cooler than stock plugs (and certainly if stock), they are probably ready for a replacement. Got some br7s on the way.
I dunno what's in the motor now. If they are cooler than stock plugs (and certainly if stock), they are probably ready for a replacement. Got some br7s on the way.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
TECH Apprentice
Joined: Nov 2009
Posts: 367
Likes: 0
From: Kentucky
With my HSW MicroEdge Controller tied into my TPS and I have the WOT activation set at like 4.45 volts and I can hammer the gas and see the voltage count up on the LCD screen before the Noids will fire. It's almost like a half second before it hits. Thought about lowering the volts to like 2.75 but haven't logged anything to see if I would ever hit that without want to go WOT.
With my HSW MicroEdge Controller tied into my TPS and I have the WOT activation set at like 4.45 volts and I can hammer the gas and see the voltage count up on the LCD screen before the Noids will fire. It's almost like a half second before it hits. Thought about lowering the volts to like 2.75 but haven't logged anything to see if I would ever hit that without want to go WOT.
