Where to run main N2O line?
#1
On The Tree
Thread Starter
Join Date: Nov 2002
Location: Newfoundland, Canada
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Where to run main N2O line?
Getting through my nitrous install and still havn't ran my main feed line yet. I have the bottle mounted in the spare tire area and was wondering where the best place to run the n2o line would be? I figure go down through the rubber grommet but not sure where to go from there? GMHTP drilled holes and zipped tied the line along the car but not sure about drilling the bottom of my car like that. Any ideas/pics appreciated.
#2
TECH Junkie
iTrader: (9)
Join Date: Jun 2003
Location: Winter Garden, Florida
Posts: 3,428
Likes: 0
Received 0 Likes
on
0 Posts
I'd venture to say that a lot of folks just run it inside the car under the carpet. I guess there is a little extra safety by going outside the car, but the reality is you still have the bottle and end of the line in your car since you don't have a trunk. I don't see braided lines having a high failure rate and inside the car is NHRA legal. Just my .02.
#6
On The Tree
Thread Starter
Join Date: Nov 2002
Location: Newfoundland, Canada
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
I have already run some wires through the grommet behind the ECU, wish I had to run the line as well. At least I know a few tricks this time
Thanks guys
Thanks guys