NX rail tech question
Thread Starter
7 Second Club
iTrader: (11)
Joined: Jul 2002
Posts: 8,758
Likes: 9
From: Port Tobacco, MD
NX rail tech question Can you supply both fuel and nitrous from one side of the rail? Every pic I have seen has the fuel on one end and the nitrous on the other end.
Phil
Phil
Thread Starter
7 Second Club
iTrader: (11)
Joined: Jul 2002
Posts: 8,758
Likes: 9
From: Port Tobacco, MD
Originally Posted by Bad Habit Bird
Yes you can. I believe the reasoning for having the noids on each side is because you don't have enough room for both on one side of the rail.
I guess I am going to have to measure... 
Closed ex-Sponsor Account
iTrader: (1)
Joined: Jul 2004
Posts: 2,797
Likes: 0
From: Wichita Falls, TX
Yes 2 fittings can be installed into one end of a rail.. You will need a hard 90' fitting, and a straight fitting.
You will also need a mill, you have to offset the tapped holes center lines farther apart than the current thou rail holes. A drill will not cut it. The large hole or tapped hole will need to be set up so the most outer part of your tapped hole rides the edge of .187 rail throu hole. It is not done for 2 reasons, Time and it is a pain in the ***. lol
\
Ricky
You will also need a mill, you have to offset the tapped holes center lines farther apart than the current thou rail holes. A drill will not cut it. The large hole or tapped hole will need to be set up so the most outer part of your tapped hole rides the edge of .187 rail throu hole. It is not done for 2 reasons, Time and it is a pain in the ***. lol
\
Ricky
