I installed the TNT kit this weekend and got everything ready. I went to test the kit and the solenoids clicked like they're supposed to. My only question is....I didn't have any nitrous or anything when I tested the kit, so did it spray fuel into the intake when I tested it? Do I need to do anything to get the fuel out? I haven't fired the car up since I've had the kit on.

 

IF your worried about anything being in the intake. I believe LS1's have what's called Clear Flood to us ASE Techs which is engaged by holding your gas pedal down to WOT which ungrounds the fuel injectors and just basically dumps the cylinders while rotating over...

 

Thats a new one to me.

 

I've had the pedal WOT several times while looking at mounting the microswitch. Both by openening the TB wide open and by pressing the gas pedal down. But I thought I had to physically turn the motor?

 

WOT while cranking (Turning Key) if it does start remove foot immediately this "Clear Flood Mode" was adapted in OBD II system for diagnostic testing...

 

Are you an ASE Tech, or had Automotive Training...

 

I can almost guarantee the car will start...it always has. So you're saying I should try to start the car while holding the pedal to the floor?

 

No but I did stay at a Holiday Inn last night.

 

 

are you asking if it's okay to start your car? if so yes. start it. you didn't hurt anything by doing that. xXTransam is correct it does disable the fuel if you hold the pedal WOT. this is for diagnostics and to prevent the common customer from simply flooding the vehicle because they don't know how to start it.

 

Yea, I just want to make sure it's ok to start my car since I thought that I had sprayed fuel into the intake by simply testing the kit.