Hello all,
So I got a nitro daves plate kit with purge, fpss, and the nitro daves window switch. Well I wired some thing on the relay wrong and everything is fixed and wired ok now. Well the window switch has a two stage set up... i programmed the stage one which I am hooked up to and the stage two is just all set at 000 and unwired. Well when i flip the arming switch fuel just dumps out of the noid(dont know what the nitrous is doing...bottle not hooked up). So i program stage two in the window to match stage one and it stopped dumping out the fuel....Is there any way to test and make sure everything is working right? I really dont wanna blow up my motor. Could there be somethin up with the window switch or maybe the noids?? Any help would be great!!!!
Thanks

 

Since you are only running one stage the wire for stage 2 should not be hooked up. Just tape the end and tie it off.

Dean

 

Sounds like you have the relay wired wrong.

Be careful, if the nirous noid is activationg with the fuel noid (it should if wired right), you may burn the coil out on the nitrous noid (it relies on the nitrous for cooling).

Check your relay wiring. Also your WOT function (or mechanical WOT switch if your running one).

As Dean said tape up the second stage wire (do not cut it, you will hurt the resale value of the window switch if you go to sell the kit).

 

I did have the relay wired wrong but all is good now...When I got the wireing all figured out is when the noids started to screw up on me. I have the 2nd stage taped off right now. Is there anyway on the window that I would need to program stage 1 and 2 to match for it to work?? When stage two was programmed to all 000 is when the fuel was just gushing out, then when I programmed it to match stage one it stopped....Is there a way I can test the window or should I try and talk nitro daves into sending me a new window??