http://www.dfwstangs.net/forums/show...referrerid=414

A little something I whipped up for one of my customers. I just figured I would show it off a bit .

 

NICE!!!!

Josh S.

 

Yeah that is one sick setup

 

Where did you get the adapters to mount the injector fuel rails to the intake?

 

Thanks guys , I was kinda proud of it. The injector rails are just spaced with a piece of billet aluminum(I had to fab it up).

 

Looks smooth. Any idea on how well the NXL nozzles would work under a lower fuel pressure? Like 10psi for use with a secondary n2o fuel supply?

 

Do you have any more and/or can make some? I am looking for something like them

 

How much did that cost? Email the details please I'm interested in something exactly like that

My email is MUSTANGEATER1283@cs.com

 

Same here... my e-mail is 00firehawk@fastrides.net

 

Guys the kit installed on your manifold is @$1700. If you would like more details E mail me sean@mmtracing.com or just gimme a call 469 721 3080.

Xaon, I'm not sure how well the nozzles would work with a low presure system. I can give Ricky at NX a call and find out if they have done any testing at that fuel pressure.

LS1290, I had my machinist make them up for me. Do you have the same fuel rails as shown in the pic?

 

I sent you email on this

 

Here is a few more pics for you guys of the finished product
web page

 

That thing looks sweet.


Now what all does the $1700 price include?

 

Sent you mail

 

$1700 covers the Base kit and installation of the system on your manifold.

 

Ironic how its on a stang message board

 

Very nice! Have you had a chnace to spray your stock-bottomed-end car with at killer setup yet?

Wondering if you are coming to the shootout on the 31st also?

 

Stangkiller, I am a sponsor on that site as well as here and the "other" LS1 site. Reckless, my car is destined for a little 10.5 racing, and as such is down for another month or so getting ready for that whole deal.

 

Did you get my email on the fuel rail mounting hardware?

 

ls1290, yes man I did, I'll get you emailed back tomorrow. Been kinda busy with the car in the pics for the last couple of days. Did you recieve any hardware at all with you injector rails? If so they should go right on an LS6 intake. If you are wanting to run NXL nozzles you will have to space them up a bit, it's some where around 5/8ths of an inch.