Yea, I would watch the distribution also. your in inkwon territory, however, Brad was running a single plane and even had problems with a plate. PM him for some insight, the mod that is Noyzee-Brad.

Doesn't look bad at all for a first job. I have been bending SS tubing for many years and it takes a lot of practice to get it perfect.

Is thet the Dave elbow? I am running one on my Vic Jr single plane and doing a DP Dry with soft lines, though not SS braided. Kinda like the hoses in the pic below.

Robert

 

The elbow was made by aaron at intakeelbows.com. I Hope the N2o distribution will be good. Those are TNT wet nozzles and with the fan pattern on the nozzles it seems as though it would cover each side perfectly.I wish I had not installed the intake yet I could have mocked up the intake w/elbow and sprayed some n2o through it.

 

Not that many bolts to take it back off, might be worth it.

 

Yea maybe if they are far enough away they will work fine, remember your in some uncharted territory. the spray bar style like what goes under a carb can have issues and some lean cylinders. I would check all holes and see what the plugs say. It was easier working on the intake and mocking stuff up the way I wanted, at the kitchen table, lol...

Robert