Holley Polished Stealth Ram Intake
10-30-2008, 08:04 PM
#1
LS1TECH Sponsor
Thread Starter
iTrader: (1)
Join Date: Mar 2006
Location: Kentucky
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Holley Polished Stealth Ram Intake I have a polished Holley Stealth Ram Intake part number 7540P for a Non-vortec SBC. It was used on a Dyno Motor and then just set on the shelf. It is in good shape and includes upper and lower, plenum gaskets and plenum bolts. I am asking $375.00 OBO. I am located in KY and I will ship if needed. If interested you can PM me or e-mail me @1970rs@scrtc.com.
Thanks,
Jay
Thanks,
Jay
10-31-2008, 11:18 PM
#5
LS1TECH Sponsor
Thread Starter
iTrader: (1)
Join Date: Mar 2006
Location: Kentucky
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Actually I just went out to the shop and I do have some fuel rails that will work fine. They have the regulator on in. I do not have the correct cross over for the front or a plug for one of the rails but everything else should work fine.
11-01-2008, 04:05 PM
#7
LS1TECH Sponsor
Thread Starter
iTrader: (1)
Join Date: Mar 2006
Location: Kentucky
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Not sure what you would do for that. Since the LT1 does not have coolant ports or a distributor, I would think it would be very difficult to make it work properly.
Trending Topics
02-08-2009, 02:24 AM
#11
ttt thanks jay received it and it looks great...thanks
i left you seller feedback could you please do the same for me? thanks again.
i left you seller feedback could you please do the same for me? thanks again.
Last edited by xtreamvette69; 02-08-2009 at 02:30 AM.
