LT1 for sale
01-05-2009, 09:05 PM
#1
LT1 for sale For Sale.
1997 LT1. Fully Rebuilt. Bored 30 over. 355 ci. Speed Pro Hypereutecic pistons. 11:1 Compression. Fully ported and polished factory castings. 3 angle valve job. 2.06/1.6 valves. New GM timing chain. CC306 cam. 918 valve springs. New 10 degree locks and retainers. Fluidampr harmonic balancer. ARP head studs kit. ARP engine bolt kit. Comp Magnum Pro Rockers 1.6R. Comp Push Rods. custom 6 qt oil pan. MSD Optic Spark Ignition. Water pump is setup for electric water pump. Holley 52mm Throttle Body. New TPS, MAP, OIL Pressure sensors. Fuel Rails are setup for custom stand alone fuel system. I also have another set of fuel rails that are in factory condition and can be used.
I have a good dime in this motor. It was built with a lot of time and care. No cheap parts were used and everything was gone over a dozen times.
Also comes with a facory GM 52 Tooth flywheel. Motor was balanced to this specific flywheel. Rods are factory reconditioned and the whole motor was cryo-treated. Also comes with a jegs oil cooler kit and all hardware. Oil pan was made to clear a Porsche 944 crossmember. But it is a LT1 oil pan and will work on any car equiped with a LT1.
Looking for $4000 shipped OBO. Make me an offer. This needs to go. Got to get some stuff paid off.
__________________
1997 LT1. Fully Rebuilt. Bored 30 over. 355 ci. Speed Pro Hypereutecic pistons. 11:1 Compression. Fully ported and polished factory castings. 3 angle valve job. 2.06/1.6 valves. New GM timing chain. CC306 cam. 918 valve springs. New 10 degree locks and retainers. Fluidampr harmonic balancer. ARP head studs kit. ARP engine bolt kit. Comp Magnum Pro Rockers 1.6R. Comp Push Rods. custom 6 qt oil pan. MSD Optic Spark Ignition. Water pump is setup for electric water pump. Holley 52mm Throttle Body. New TPS, MAP, OIL Pressure sensors. Fuel Rails are setup for custom stand alone fuel system. I also have another set of fuel rails that are in factory condition and can be used.
I have a good dime in this motor. It was built with a lot of time and care. No cheap parts were used and everything was gone over a dozen times.
Also comes with a facory GM 52 Tooth flywheel. Motor was balanced to this specific flywheel. Rods are factory reconditioned and the whole motor was cryo-treated. Also comes with a jegs oil cooler kit and all hardware. Oil pan was made to clear a Porsche 944 crossmember. But it is a LT1 oil pan and will work on any car equiped with a LT1.
Looking for $4000 shipped OBO. Make me an offer. This needs to go. Got to get some stuff paid off.
__________________
