396 LT1 BOOST stroke KIT Brand NEW in the boxes
07-29-2009, 05:46 PM
#1
8 Second Club
Thread Starter
iTrader: (76)
Join Date: Jun 2004
Location: Goshen NY
Posts: 2,902
Likes: 0
Received 0 Likes
on
0 Posts
396 LT1 BOOST stroke KIT Brand NEW in the boxes Callies Crankshaft, 3.875" stroke/2.100" Pin Size/350 Mains/1pc Rear Main/5.85" Rod
srp LT1 Forged Blower/Turbo(up to 20lbs) D-Shaped Piston set w/ -15cc Dish, 4.030" BORE / 3.875" Stroke /.927 x 2.9500 Wrist Pins Included , Rings included
Manley Performance Sportsmaster Connecting Rods, LT1, 5.700" Rod Length, .927 Wrist Pin, ARP rod bolts.
This setup was balanced. all you need is a block .030 over and ur ready to roll
this kit cost 2200.00 NEW Plus 200 to balance.
PRICED TO SELL 1500.00 PLUS SHIPing
http://cgi.ebay.com/ebaymotors/ws/eB...m=110427019368
srp LT1 Forged Blower/Turbo(up to 20lbs) D-Shaped Piston set w/ -15cc Dish, 4.030" BORE / 3.875" Stroke /.927 x 2.9500 Wrist Pins Included , Rings included
Manley Performance Sportsmaster Connecting Rods, LT1, 5.700" Rod Length, .927 Wrist Pin, ARP rod bolts.
This setup was balanced. all you need is a block .030 over and ur ready to roll
this kit cost 2200.00 NEW Plus 200 to balance.
PRICED TO SELL 1500.00 PLUS SHIPing
http://cgi.ebay.com/ebaymotors/ws/eB...m=110427019368
Last edited by SSPerformance; 08-22-2009 at 03:32 PM.
Trending Topics
08-06-2009, 07:57 AM
#8
If the pistons were bigger id ****** this in a minute. Theres not enough dish to run stock heads and have a safe compression ratio in my opinion. Would make for a nasty nitrous engine though!
