EDIT: SOLD

Selling a relatively clean LM2 system with 3.5" slash tips. Originally posted in the LSX parts section, but this obviously fits LT1's as well. An adapter is required to bolt this sytem to factory 93-95 style y-pipes. Description and pictures can be found here:

https://ls1tech.com/forums/lsx-parts...back-pics.html

Asking $265 shipped anywhere in the lower 48.

 

what kind of adpater is need for the lt1 and where are u located

 

Pretty sure the Y-pipes are just shorter...I think you just need more pipe.

-Dustin-

 

I was mistaken. After some research, the "s-pipe" I have is not the LT1-specific piece I was thinking of. The piece I was thinking of can be found here:

http://marylandspeed.com/slp-lt1-lou...045-p-235.html

The adapter is apparently only required if you are bolting this system up to a factory 93-95 style y-pipe. In short, the muffler inlet pipe I have should work with the factory 96-97 f-body y-pipes, and definitely works with aftermarket y-pipes. This system was actually taken off of a 96 LT1, with jet hot LT's and ORY.

I am located in the south Houston, TX area.

 

i have a 97 ss longtubes custom y pipe so should work then right

 

will this bolt directly up on a stock 96 z ?

 

i second that motion lol i have a borla cat back now but would like to have these

 

For a custom y-pipe, there's no way for me to say for certain. However, if your custom y-pipe empties at the same location as the factory 97 y-pipe did, I can say "most likely yes".

Assuming a stock 96-97 y-pipe, Yes.

See above.

 

sold....