Painting Block
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: Jul 2013
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Painting Block
So, I picked up a block from a man that has been painted purple... and that doesn't really go well with the current Pearl White, or the planned Ultrasonic Blue Mica paint jobs.
The block is already assembled and torqued - ready to go... As far as I know, since it has been greased with assembly lube, bringing it to be tanked is out of the picture.
How can I re-prep the block surface for good adherence for the paint? Could I spray over it with a self etching primer to eat down into the existing paint?
I am positive this has been answered at some point in time, but I am only turning up having it vatted, media blasted or taking a wire wheel to it... is there some other way that is easier? Not trying to cut corners... I'm just trying to not have to do a ton of extra work.
The block is already assembled and torqued - ready to go... As far as I know, since it has been greased with assembly lube, bringing it to be tanked is out of the picture.
How can I re-prep the block surface for good adherence for the paint? Could I spray over it with a self etching primer to eat down into the existing paint?
I am positive this has been answered at some point in time, but I am only turning up having it vatted, media blasted or taking a wire wheel to it... is there some other way that is easier? Not trying to cut corners... I'm just trying to not have to do a ton of extra work.
#2
TECH Resident
iTrader: (4)
If its the block im thinking of (did you buy it off a guy in md?) its powdercoated. (cant imagine theres to many purple ls motors out there I know the original owner of it.) My advice would be to scuff it a little with sand paper, use a good engine enamel primer, then spray it whatever color you desire.
#7
TECH Resident
iTrader: (4)
well in that case more power to you, but again no it wouldnt be a good primer for regular paint. It would be very hard to do a whole vehicle (expecially an f body) because you have to electrically charge whatever your spraying to get the powder to hold to it. This leaves everything from the doors foward on an f-body out of the question. Even if the car were all metal it would still be quite an ordeal.
Trending Topics
#8
Teching In
Thread Starter
iTrader: (2)
Join Date: Jul 2013
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the replies. The block was purchased in N. TX. The man said it was for his wife's truck - IDK. In any case, I had asked and he assured me it was just rattle can. I just didn't know the best way to attack this... generally when I paint, I get as much if not ALL of the previous coating off to allow excellent adhesion.
What if I scuffed it, used a self etching primer and then painted over that? Do ya'll think that would be enough? It's going to be black, so it will definitely overpower the purple, but I want to make sure it doesn't start flaking and looking like ****. I planned to clear it a few times to hopefully protect the paint as well.
What if I scuffed it, used a self etching primer and then painted over that? Do ya'll think that would be enough? It's going to be black, so it will definitely overpower the purple, but I want to make sure it doesn't start flaking and looking like ****. I planned to clear it a few times to hopefully protect the paint as well.