F/S SBC 1 7/8 headers for 4th gen
#1
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
SBC 1 7/8 race headers for 4th gen. What I have for sale is a brand new set of 1 7/8 Headman Hustler cermaic coated headers for the forth gen Firebird and Camaros. I purchased these brand new from Headman race division and will no longer need them. I had wideband O2 bungs installed on each collector. There are some minor scratches from trial mounting but nothing too bad. These sell for just a bit over $800. I'll let them go for $650 plus shipping. These are some very nice headers for a small block in a fourth gen!!!
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3661.jpg)
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3663.jpg)
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3662.jpg)
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3664.jpg)
Thanks,
Dave
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3661.jpg)
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3663.jpg)
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3662.jpg)
![](http://i522.photobucket.com/albums/w347/DaCajun_2008/DSCN3664.jpg)
Thanks,
Dave
#7
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
That's a very good question. I guess I should have mentioned that. Due to the large primary tubes "1 7/8" they have what's known as Stahl flanges. The flange bolts up to the typical SBC exhaust flange on the cyl head then the header bolts right up to the Stahl flanges. This setup is common on large tube SBC headers.
-Dave
-Dave