Weld Racing pro star draglite racing rims
#1
On The Tree
Thread Starter
iTrader: (13)
Join Date: Apr 2008
Location: odessa
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Weld Racing pro star draglite racing rims
Category: Wheels & Tires
Price: $200
Part Fits: 93-02 Chevrolet Camaro
Location (State): TX
Item Condition: Used
Engine: LS1/LS6
LS Engine?: Fits LS Engine
Size: 15'' x 8''
Bolt Circle: 5 x 4-1/2''
Rear Spacing: 4-1/2
Mickey Thompson ET Drag Slick 28.0'' x 10.5'' - 15''
M5 Compound
I have here two Weld pro star 96 series drag racing rims that came off of my 98 camaro! I would like to get 200 OBO for the set plus 45-50 total shipping which will vary from zip code! Brand new from Jegs they run 189 each. Pretty good condition were the only scratches are on where the lugs go and you will never see that because the lug nut is over it! Other than that they are in tip top condition for only being used 16 times for 16 passes on my 98 camaro! Not pictured but included are the lug nuts and washers which are 12mm! They will fit stock studs! and the center caps for the rims as well are included! These rims have also been drilled and taped for tire screws as well on both sides of the rim, 8 screws on each side! If you would like you can also have these Mickey Thompson ET drags as well! they are used and probably have 15-20 passes left in them and are in good condition! They are free if you will pay the additional shipping on them because I will have to pay 10 bucks a tire to have them removed! But its your call!
Sizes and dimensions are listed above on the rims and tires!! PM me with any questions! I respond much quicker as they come straight to my phone and I am not up and on the site everyday!!
#6
On The Tree
Thread Starter
iTrader: (13)
Join Date: Apr 2008
Location: odessa
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Yes the Backspacing is 4.5 and it all depends on what kind of tire you are using for the length it will stick out! I ordered 5.5 but when I mounted them they stuck out of the fender well about 1/4 inch, not much and it doesn't look bad at all. It was too late for me to send them back because the tires were mounted and that was my fault for not checking them! So I got stuck with them! They look fine just stuck out a tad!!