Guaging intrest on some TSP PRC Terminator heads That yeild 450rwhp. Simple H/C/I
08-04-2010, 12:49 PM
#1
Guaging intrest on some TSP PRC Terminator heads That yeild 450rwhp. Simple H/C/I Category: Racing Parts
Price: $1100
Location (State): TX
Item Condition: Brand New
Engine: LS1/LS6
LS Engine?: Fits LS Engine
Well its starting to be that time where im looking to build a new set up but would like to have a seller on stand by when parts start coming off. What I have are some TSP PRC Terminator heads 200cc with dual PRC valve springs. These heads are out of the box milled to 59cc.
I ran these heads with LG's G5X3 cam and have only had good results. Below is the complete set up and graph. Like I said this combo is very very simple. I would like to get $1100 for them shipped paypal included
Mods:
PRC 200cc Terminator heads 59cc
G5X3 234/242 .598 .610 114 LSA
SS Chrome 1 3/4 long tubs and X pipe, cat-less
TSP under drive pulley
Harden 7.350 push rods
Fast 90mm intake ported
Cold air kit
Stock short block with 138k miles
Stock LS2 90mm TB ported
Stock LS7 lifter
Stock mass air with 85mm mass air housing
Stock fuel system: pump, injectors, fuel rails
Stock water pump
Stock roller rockers
Stock LS6 oil pump
Stock LS2 timing chain
Stock A/C Delco 7mm wires
NGK TR6 plugs for NOS
Bassani Catback, no cut-outs
Pump 93
18'' wheels
Well the car hit 451rwhp and 413 rwtq. Just remember this is a nitrous tune and not an all motor tune, btw my tuner said if the car was tuned N/A is would of hit @ 470rwhp.
Im sure some one with a electric water pump, bigger headers could get close to 500rwhp mark.
Last edited by regorih383; 05-11-2011 at 11:13 PM.
08-04-2010, 10:34 PM
#3
Staging Lane
iTrader: (3)
Join Date: May 2009
Location: St. Louis
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Interested but have questions? How many miles on heads? What cr would that be with stock bottom and stock head gasket? Any pics of any terminator head cant seem to find any. flow #s any if not yours?
08-05-2010, 04:52 PM
#6
I have no flow sheets for the heads
That high graph line was done on a almost empty bottle, my fault
heads have less that 15k miles
this is the only pictures I have of them, this was when they went on
Trending Topics
05-12-2011, 08:30 PM
#20
On The Tree
iTrader: (7)
Join Date: Nov 2009
Location: Tigard, Oregon
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
They are based on the Edelbrock castings! Thats a Bad *** Deal 1100$ shipped! 200cc intake port for great low speed response, These would be great heads for a Daily driver hot rod
I wish i saw these before i just snatched up a damaged set of AFR 205's !
I wish i saw these before i just snatched up a damaged set of AFR 205's !