/ */ custom built 2.5" mandrel bent stainless true duals over the axle w/ X-pipe */ *
#1
/ */ custom built 2.5" mandrel bent stainless true duals over the axle w/ X-pipe */ *
Category: Engine - Exhaust
Price: $400
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): PA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
I am selling my current exhaust to be able to afford to build my new 3" dual exhaust.
It is 2.5" Mandrel Bent Stainless Steel and features a Pypes X-pipe. The duals go over the axle and into two Pypes Bullit Mufflers. It is currently set up for a CME, but it will fit Trans Am bumper cutouts since the tailpipes are adjustable side to side. I would not like to sell it with the CME tips but if I did I would need to charge more to be able to afford a replacement.
I custom built this kit. It took many many hours to build and I am selling it for way less than it cost me to build it. It is the tightest fitting dual kit I have ever seen. I have never bottomed the kit out on my lowered car. No shortcuts were taken to build this kit and its not half assed. I have revised it a couple of times due to various different changes. It will fit aftermarket rears. The last mod was the dual electronic cutout dumps. They don't hang any lower than the headers do. I used a UMI Panhard Bar Relocation kit since having one pipe go between the panhard is a given that it is gonna rattle. You would have to buy this as I need mine for the 3" TD's. The header connections shouldn't be an issue as well. The front legs are adjustable. I also took into consideration of the placement of the joints. Each part is removable without disassemble of the whole exhaust or car!
I will also offer my HPM Tunnel Mounted (short) Torque Arm with the exhaust. It is a unique design and is one of the shortest torque arms available today (faster launches). You don't see to many of them but they are built tough. I am asking $125 for the T/A. If you do not need a torque arm cause you have a factory one of aftermarket one, don't worry, my exhaust fits it.
All hangers and band clamps are included in the kit.
This system was connected to QTP headers.
Shipping is not gonna be to bad. All of the parts break down and fit into a pretty small box. I use high quality foam packing to make sure the parts don't get damaged. PM me your zip code for a quote.
EXHAUST ONLY $400
EXHAUST AND CME $600
Make me some offers. I am willing to make deals to get rid of it.
HERE IS 2 PICS & ITS STILL A LITTLE DIRTY. I will have more loaded pics of the exhaust on the car shorty.
DOES FIT TRANS AM BUMPER CUTOUTS
Last edited by 9t8z28; 02-07-2011 at 12:48 PM.
#4
Here is a sound clip. I am sure that it is not what everyone is looking for. I have another of it idling on my iPhone that I will try to download.
VIDEO >> http://s118.photobucket.com/albums/o...t=MVI_2047.mp4
VIDEO >> http://s118.photobucket.com/albums/o...t=MVI_2047.mp4