Harland Sharp Adjustable LS1 Rockers - Part# SLS17A
05-04-2011 | 05:35 PM
#1
Thread Starter
CARTEK Racing
iTrader: (13)
Joined: Nov 2001
Posts: 2,182
Likes: 0
From: East Brunswick, NJ
Harland Sharp Adjustable LS1 Rockers - Part# SLS17A Category: Engine - Intake/Fuel
Price: $395
Part Fits: 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO
Location (State): NJ
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
The set was taken off the car in December, sent to Harland Sharp for inspections. One rocker and two bolts were replaced and shipped back to me.
The reason I have not put them for sale earlier is because I am superstitious and I wanted to make sure the car was fine with the new rockers which took FOREVER to get here.
Ratio is 1.7:1
New MPSR is $598, but I have found them cheaper at:
http://www.byunspeed.com/product_inf...oducts_id=3161
for $505.
Selling them for $395-OBO Shipped to Con-US
Make an offer.
Payment via Pay-Pal and shipped via USPS Priority Mail.
Thanks for looking.
Last edited by WS6TransAm01; 05-06-2011 at 01:00 PM.
05-04-2011 | 11:54 PM
#2
I'm gonna ask the dumb question for the day does having adjustable rockers mean that you can use stock length pushrods in an instance where non stock lengths should be used? Or is there another reason for the adjustment?
Thanks!
Thanks!
05-05-2011 | 10:44 AM
#3
Thread Starter
CARTEK Racing
iTrader: (13)
Joined: Nov 2001
Posts: 2,182
Likes: 0
From: East Brunswick, NJ
Not a stupid questions. The adjustment range is usually only around .030" so if your stock pushrods are out by .015" or .020" then I suppose you could. Otherwise there are designed to set valve lash.
Either way
Back to top for Thursday morning
Either way
Back to top for Thursday morning
Trending Topics
05-07-2011 | 09:55 PM
#9
Wow
My builder just put the Harland Sharp rockers in my new forged iron block ls6....How come after a few dyno pulls and a little running caused one to go bad???that sucks, this worries me now...maybe i should have gone Jessels...
My builder just put the Harland Sharp rockers in my new forged iron block ls6....How come after a few dyno pulls and a little running caused one to go bad???that sucks, this worries me now...maybe i should have gone Jessels...
05-07-2011 | 10:07 PM
#10
Thread Starter
CARTEK Racing
iTrader: (13)
Joined: Nov 2001
Posts: 2,182
Likes: 0
From: East Brunswick, NJ
Jessels are a rip-off. I'm running T&Ds now.
I wanted the rockers to be inspected before selling them. Did not want to sell something that was not 100%.
According to Harland Sharp the replacement was due to an original build error. And they have never seen it before.
You will be fine with these rockers. It all depends on your cam and RPM.
All PMs have been answered.
I wanted the rockers to be inspected before selling them. Did not want to sell something that was not 100%.
According to Harland Sharp the replacement was due to an original build error. And they have never seen it before.
You will be fine with these rockers. It all depends on your cam and RPM.
All PMs have been answered.
