Category: Engine - Complete Motors
Price: $1600
Location (State): MS
Item Condition: Used
Shipping Information: Item Can be Shipped
LS Engine?: Fits LS Engine

I have my motor out of my 2002 trans am. It is a stock bottom end with just under 30,000 miles on it. the motor was stock till about 18000 miles. It now has ported 862 5.3 heads milled to 58cc, aftermarket valves 2.00/1.57 if i remember correctly, patriot extreme dual valve springs w/ 10-12000 miles on them, so may need checking, hardened pushrods, 3 angle valve job and were hand ported by Hal Coates of Koziusko, MS.The shortblock has never been into, its stock from the factory. It has a ported LS6 oil pump and a Rollmaster Double adjustable timing chain. It has a futral motorsports 232/236 .598/.603 LSA 112+4. This set up with an ls6 intake, ported stock throttlebody,headers, through a 4l60 and yank 4000 extreme converter on 28 inch tires made 44x/39x and made 43x/38x through a th350 on 28" tires and a 4000 stall the motor does not come with an intake... It comes with front, rear, valve, and valley covers as well as some sensors. if interested, i have pics.


Edit:
I had a potential buyer and per his request i removed the heads to take pictures of the pistons and cylinders. After removing the heads, i saw and remembered that i had problems with a vendor's heads when the company first began, and after crank up i ran it about a quarter of a mile and had 4 springs fail on the front 2 on each side, leaving ptv scars on the front 4 cylinders. This has not affected the motors performance in any way!!! I have run this set up with the futral cam and the 862 heads for 10-12000 miles and have had no problems. I have included a pic of the worst one to show this. Again, this did not cause any problems with performance as you can tell by the dyno numbers and a conservative tune. I will assemble back together with new gaskets and bolts, or just send them along with the motor. Its up to the buyer.after my findings, i wanted to edit my info, cause it cost me a sale.
Price is 1600+shipping and fees.

thanks,
David

 

Oops, forgot the Cam.
It is a futral 232/236. .599/.603 112+4 lsa

 

PM me if you want to sell the pan and timing/rear covers.

 

Not wanting to sell covers just yet. Plus it has a truck pan on it to keep the motor sealed up. If I decide to break it up ill let you know. Thanks

 

Bump...

 

Ttt: )

 

Ttt

 

Sale pending

 

Bump to top for Editing info

 

Sold!!!