Category: Audio/Video/Electronics
Price: $1500
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird, Front wheel drive vehicles
Location (State): KY
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine

GMMP Single Plane (Cathedral port)
Barry Grant Speed Demon 850 W/fuel line *SOLD*
return spring & bracket *SOLD*
Aeromotive regulator 027-13301


Holley Blue Pump *SOLD*
Jegs Billet in line filters (2)
Aluminum 1 gallon cell
Jegs Fuel log W 2 Holley 12-803 regulators

Direct Port Nitrous setup
Inductions Solution Nitrous N20 solenoids
NOS Fuel solenoids
NOS Stainless annular nozzles
Large assortment of jets
-6 Nitrous supply line
Bottle heater
NOS 2 stage mini progressive controller

I will also include all the lines and fittings that I used to run this setup on my car. I also ran a plate kit along with this witch is why there are 2 803 regulators on the fuel log.
Most of the parts listed are in like new condition. No bottles included.

I have well over 2K in this setup I would like to get $1500 OBO

 

Would you sell just the stand alone?

 

I'd like to keep it all together if at all possible.

 

May trade for a nice set of drag wheels...

 

Carb and Holley Blue pump are sold.

I am willing to seperate this stuff so shoot me a PM if you are interested in a certain item.

 

How much for just the carb intake. I'm assuming nitrous bosses already drilled?

 

Yes, the Direct port is still installed on the intake.

If you want the intake by its self I will do $200.00 plus shipping for it.

 

Is the whole stand alone sold or just the fuel pump?

 

Yea, I think I may want the intake plain no nos. Do they make plugs to plug the holes or would it be too restrictive? I wanna run nos someday but not anytime soon

 

Josh, I still have the 1 gallon cell, lines, filters,regulators, and fuel log. The tank is not specifically designed to fit an F body. It will require some cutting and fitting. I had it where the battery was but i had to cut out the metal where the trey bolted down.

bowtieboySS427, Some 1/16? NPT plugs would thread right in the holes and would not create any type of restriction at all. I will even supply and install the plugs if you purchase the intake.

 

can i get a phone # for you i could pick intake up save you on shipping....