Category: Accessories
Price: $8500
Location (State): Can-SK
Item Condition: Used
Shipping Information: Item Can be Shipped
LS Engine?: Fits LS Engine

I bought from another member but have decided to change directions.
Located in Sask, Canada.

440 LSX short block
LSX block
Callies Dragon Slayer crank
GRP PRO SERIERS ALUM RODS
DIAMOND pistons 8cc dome , Gas ported , coated tops & skirts
ARP main studs
comes with custom n2o cam/ timing chain set/oil pump
268/278 780 lift
Motor has 26 passes on it , rods have 50 on them

Brand new trick Flow 265 heads
6 bolt
Have titanium intake
stainless exhaust.
64CC
Heads have the bigger n2o exhaust port
These heads retail for $4300

$8500 you pay shipping and paypal

 

dang!!! awesome setup! what did it put down? what did it run?

 

what about just the block alone? if so iron or aluminum?

 

this come from forum member ssperformance?

 

It should go 8.50s on a 250 shot

Block all alone or short block alone? I'd consider selling the heads and shortblock seperate.

Its an iron GM LSX block

Yes it came from ssperformance. I was going to swap the pistons and make it a boosted motor, but bought something else.

 

I would be interested in just the bare block? sorry for the confusion.

 

Damnit i wanted that!

 

Sorry, I'm not going to part that out

 

Bump for ya, would have gladly picked this up if I already didn't just have one built.

 

What compression?

 

Depending on head gasket choice around 14.5:1

 

Someone must want to make big power

 

Pick me, I do!!!

 

$5000 for the short block
$3300 for the heads

 

to the top

 

Is it all still together or apart? I still like to have it...

 

Shortblock is all still together. Heads are still new in the box

 

would you have to change the pistons out for pump gas? how large off a shot was it built for? is it 24 or 58 reluctor?

 

Yes you would have to change the pistons. But if you were doing that for a street motor you probably dont ant the aluminum rods in it either.

It's built for over a 250 shot

I'm pretty sure its 24t but I'll go verify

 

Are the heads still available? Are they setup for solid roller?