Need a couple Ttop Parts
#1
TECH Apprentice
Thread Starter
iTrader: (8)
Join Date: Dec 2006
Location: Western North Carolina
Posts: 381
Likes: 0
Received 0 Likes
on
0 Posts
Need a couple Ttop Parts
1.Need the drivers side weatherstrip that runs down the pillar and on the outside of the ttop. Not sure if its a whole piece or pieces.
2.At the front of the part that seperates the ttops in the middle ,there is a piece that looks like it is just a cover to make it look better.
Hope this makes sense. If not, ill get a part number when I get home tonight.
EDIT: Got the parts.
2.At the front of the part that seperates the ttops in the middle ,there is a piece that looks like it is just a cover to make it look better.
Hope this makes sense. If not, ill get a part number when I get home tonight.
EDIT: Got the parts.
Last edited by Red97LT1; 10-12-2011 at 08:40 PM.
#3
Staging Lane
iTrader: (48)
Join Date: Jul 2003
Location: IL
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Are you talking about the weather strip that is actually mounted to the car that surrounds the entire door/t-top area? If so I have that. I also have the upper black T bar as well, pm me if interested.
#7
TECH Apprentice
Thread Starter
iTrader: (8)
Join Date: Dec 2006
Location: Western North Carolina
Posts: 381
Likes: 0
Received 0 Likes
on
0 Posts
The weather stripping does goes around the complete door and I took a picture of the T bar missing the piece in front.I had my glass replaced and they must of lost or broke it.I assume it's part of the tbar. PMs Sent.
Trending Topics
#8
TECH Senior Member
iTrader: (71)
That is just a little rubber piece pushed in there... It is a pain to get in there I believe. The one on my white car kept popping out so I finally ended up just removing it.
BTW... Take your tops off, tape everything off.. Get some lite sand paper and some alcohol.. Scuff up that black bar, wipe it down.. Get Krylon Fusion (I used satin, you could do gloss) and spray 4 lite coats on it.
As long as you prep correctly and you are half *** decent with a spray can, it will look like it came from the factory that way.
I didn't clear mine and two years later it still looked perfect. You could if you wanted to.
Just a tip.
BTW... Take your tops off, tape everything off.. Get some lite sand paper and some alcohol.. Scuff up that black bar, wipe it down.. Get Krylon Fusion (I used satin, you could do gloss) and spray 4 lite coats on it.
As long as you prep correctly and you are half *** decent with a spray can, it will look like it came from the factory that way.
I didn't clear mine and two years later it still looked perfect. You could if you wanted to.
Just a tip.