MTchevy1

iTrader: (1)

Looking for a set of 1 5/8" shorties or a set of long tubes for an LS1 S10 swap. Don't care if they're coated or not. Drop me a message if you have some for sale. Thanks

the_merv

iTrader: (88)

Carshopinc is where I got mine

MTchevy1

iTrader: (1)

Thanks merv, I will check them out if I end up buying new. I was hoping to find a used set to keep cost down because they're coming back off next year for a turbo setup. Just want my truck back on the road for now!

HPbyGD

Sanderson sells them and some of the kits use there headers.

Gary

bowtieboySS427

iTrader: (23)

I may be willing to sell my brp 1 3/4 mids. they are the headers that are all ran inside the frame and do not hang lower than the oil pan. Gotta run the brp mounts though. My solid carshop mounts had me beating the floor boards to fit. Headers are coated and were never ran. I didnt get the truck done for any racing this year. Now that Im buying a tig soon, Im going to fab up some LS1 style Fenderwell exit headers this winter. BTW, those shorty 1 5/8" are very comparable to factory manifolds.

Need 400 Shipped though and Im pretty firm on that.

Thanks

the_merv

iTrader: (88)

How comparible?

AceHaag

iTrader: (12)

I got a pair of mid lengths I had built along time ago that I would sell for 200 shipped. they are 1-3/4 tubes.

MTchevy1

iTrader: (1)

Thanks for the replies, guys. Bowtie, I didn't see the brp mounts listed by themselves on their website, only in the kit. Do you know if they sell them separately?

Acehaag what mounts are you running with those? Do they hit the frame at all? Any frame notching required?

AceHaag

iTrader: (12)

I had made my own mounts. I did the swap before it was main stream like it is now. they cleared the frame because they were custom built for the truck. I was throwing it out there if you wanted to give it a try.