LS1 knock sensor harness
#2
TECH Junkie
iTrader: (100)
I have one. It looks like the previous owner added about 6-8" of length to it between the middle sensor and rear plug. The crimped the extension on and wrapped it in black tape. I can cut it back down to size, solder & heat shrink it for you if you want. let me know. $10 shipped ground sound cool?
David
David
#4
TECH Junkie
iTrader: (100)
sure: dmcafee@pacbell.net
Dont forget to send your address.
In the first, you can see the connector. In the second pic you can see where the stock plug ends (on the top left) and continues on about 15" towards the right. The guy that did this must have been using the intake in the opposite direction. Anyway, do you want me to shorten it to stock length?
David
Dont forget to send your address.
In the first, you can see the connector. In the second pic you can see where the stock plug ends (on the top left) and continues on about 15" towards the right. The guy that did this must have been using the intake in the opposite direction. Anyway, do you want me to shorten it to stock length?
David
#7
TECH Junkie
iTrader: (100)
Nope, I need a set my self. I bought a stainless engine alan bolt set, and it just provided flat washers, but the valve covers appear to have a bowl shaped base. I thought a rubber washer would go there, but I could be wrong. Let me know if you find them anywhere cheap.