torque management
Thread Starter
12 Second Club
iTrader: (1)
Joined: Jul 2007
Posts: 98
Likes: 0
From: highland, michigan
i think this is the problem just looking to see if i am correct.
the car shifts normal while cruzin around but if i do a wot run it seems to bog down after 2nd gear shift to 4500 rpm and very slowly climbs out of it unless i let of the gas.
the car shifts normal while cruzin around but if i do a wot run it seems to bog down after 2nd gear shift to 4500 rpm and very slowly climbs out of it unless i let of the gas.
I'm not sure if you mean that happens after disabling TM or while leaving it on. I'm running the standard slp diablo tune which I believe has a fair amount of the TM removed. I find it does get rid of that little bit of lag that I had. But then again your are running a totally different and more powerful setup than myself. Are you running the stock 4l60e on that?
Torque management only persists for the duration
of the shift (or actually a bit less). A bog that takes
a long time to go away, is more likely a knock retard
event. Have you been scanning?
of the shift (or actually a bit less). A bog that takes
a long time to go away, is more likely a knock retard
event. Have you been scanning?
Trending Topics
Thread Starter
12 Second Club
iTrader: (1)
Joined: Jul 2007
Posts: 98
Likes: 0
From: highland, michigan
went to the tuner today, it turned be the tps due to the fact i ground down the throttle stop to far so when i was at full throttle it was past the point where the tps could read it



