Codes p0102 and p0803 Need help..
Codes p0102 and p0803 Need help.. I recently picked up a 6 speed 2002 z28 that had not been run for a while. The car has 47k miles has heads, ASA cam , slp long tube headers and basicly full bolt ons. It has the p0102 and p0803 codes. I tried swapping the mass air flow sensor and it still shows to have the p0102 code. It also seems kind of hard to get it into reverse. Like its hard to push the shifter over to where reverse is at. I am not sure if the previous owner had the same problem or if this is just something caused by the car sitting with out being ran. It smells like the car is also running rich at idle.
Any one have any suggestions where I should start looking first?
Any one have any suggestions where I should start looking first?
Ok I found the eng sen fuse blown so now im going to have to go thru the o2 sensor wires with a fine tooth comb t osee if I can find a short. Im thinking probly on the passengers side. I saw already where some one put some kiind of heat wrap on the wires were they were close to the header on that side. Man slp headers kind of suck I guess.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
