lsx_production

I have my aem uego connected to pins 2 and 5 on a male db9 connector. I have that connected to a female db9 to rj11/12 adapter and an rj11 cable running to the flashscan v2. from what I have read and researched this is the way to do it but I do not get any readings on either the v2 or efilive scan tool. if someone can double check this I would greatly appreciate it and verify if everything is right or wrong and what should I do. thank you

Pacer Racer

iTrader: (6)

If you're using the serial input make sure your tx and rx leads aren't reversed. I needed to use a null modem adapter to correct this issue