MAP sensor tuning
MAP sensor tuning I have a swap vehicle with an ecm from 02 Silverado in the vehicle and went to a hi-ram holley intake which requires ls3 style map sensor. I know this sensor is totally different my question is, can hptuners tune for the different style or do I need to find a way to make my MAP sensor fit?
MAP sensors are MAP sensors...they measure manifold pressure. Not much variance there.
Now a MAF for example is a different story as those are calibrated differently, but the MAP not so much. As long as you get a reading in the scanner you should be good to go.
Now a MAF for example is a different story as those are calibrated differently, but the MAP not so much. As long as you get a reading in the scanner you should be good to go.
kPa range and offset can vary greatly between different MAP sensors. You can make the original MAP sensor work with a piece of hose. Just tap into a manifold vacuum source somewhere. Might require some kind of hose barb fitting.
Okay Thank You, Im using same PCM and I am currently building the harness for the engine and wanted to make sure HPtuners could compensate for the different sensor but couldn't get ahold of my tuner to verify.
