Help with wide band data logging on EFILive v2

Reply Subscribe

Thread Tools

Search this Thread

Jun 21, 2015 | 10:45 AM

NuckenFuts

Thread Starter

Launching!

Joined: Feb 2014

Posts: 249

Likes: 1

From: Wisconsin

Help with wide band data logging on EFILive v2

Im almost to the end of my turbo build and its time to get a scan to my tuner to adjust my tune as its running really rich. However I got the wide band installed and got stuck on how to set it up.

The wideband has 3 wires. One is a >1 Volt (narrowband) and 1-5v (wideband )and ground.

My question is where do I connect these wires.

does Ground go to V2 scanner or any ground?
Do I use both the 0-1 and 0-5 volt wires or just 1?

Here are instructions i got with my glowshift wideband.

Last edited by NuckenFuts; Jun 21, 2015 at 10:50 AM.

Jun 21, 2015 | 11:24 AM

Rob WS6

TECH Apprentice

iTrader: (16)

Joined: Oct 2012

Posts: 349

Likes: 0

From: Maple Shade, NJ

0-5 and the ground to the flash scan. You wont be using the 1v narrowband wire at all. Then youll need to select the correct PID that goes correlates to your brand of wideband.

Jun 21, 2015 | 11:37 AM

NuckenFuts

Thread Starter

Launching!

Joined: Feb 2014

Posts: 249

Likes: 1

From: Wisconsin

Quote:

Originally Posted by Rob WS6

0-5 and the ground to the flash scan. You wont be using the 1v narrowband wire at all. Then youll need to select the correct PID that goes correlates to your brand of wideband.

Thank you very much. I have the PID for wideband so going out to test right now.

Jun 21, 2015 | 03:41 PM

NuckenFuts

Thread Starter

Launching!

Joined: Feb 2014

Posts: 249

Likes: 1

From: Wisconsin

Ok I got the PID selected and dont think its reading it.

I have the V2 connected and am recording the log via laptop on 7.5 and the Pid is has red X over it after i selected it.

Is there something im doing wrong here? Do i have to log with the V2 to get the wideband data maybe?

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last