turn on readiness monitors
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: Jul 2005
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
turn on readiness monitors
i have a 06 6.0 in my jeep, i have obd2 testing. i have a working tune but all the readiness monitors seem to be set to not available.
does anyone know exactly what Engine DTC Processing Enablers control witch readiness monitors?
https://docs.google.com/spreadsheets...it?usp=sharing
does anyone know exactly what Engine DTC Processing Enablers control witch readiness monitors?
https://docs.google.com/spreadsheets...it?usp=sharing
#5
#7
Don’t worry about the “not available” ones. Some vehicles didn’t come with AIR systems, so those codes are turned off in the computer. “Not available” is not the same as a failure. You can take your vehicle to get emissions tested and it’ll pass according to your screenshot.
Trending Topics
#8
Launching!
Thread Starter
iTrader: (1)
Join Date: Jul 2005
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
the not available ones have caused issues, i have gotten another tune that readiness monitors were able to be turned on, i have used the tune in factory emissions configuration and failed as the EGR came up "not available" everything else was ready.
#9
TECH Fanatic
iTrader: (5)
I believe you need to set those particular settings from completely off (3) to ready but not read as 'On' (2) if I recall correctly in the dtc table.
edit:
https://forum.hptuners.com/showthread.php?5558-EGR-and-AIR-removal&p=36569#post36569
see post #2
edit:
https://forum.hptuners.com/showthread.php?5558-EGR-and-AIR-removal&p=36569#post36569
see post #2
#10
Launching!
Thread Starter
iTrader: (1)
Join Date: Jul 2005
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
in efilive you need to set the dtc enablers to "X: Not Reported" and mil to "MIL" to do what you suggest.. i cannot however get EGR to show anything but "not available" no matter what i set in those tables.
i think the pcm wont work with dbw and egr..
i think the pcm wont work with dbw and egr..