Desired Shift Time
Thread Starter
Joined: Apr 2003
Posts: 2,597
Likes: 4
From: Lawrenceville, GA
Desired Shift Time Should I change the Desired Shift Time in LS1Edit after a TCI SSF3599 TC? I have increased line pressure and removed TM. What should I change the table to? Has anyone changed this table?
Bill
Bill
I have run mine as low as zeroes, but currently leave
it at 0.150. My philospohy here is to get the shift
feeling solid but if it's good enough to suit then leave
it the slack. If you tell it zero it has to give full line
(PWM) on shifts regardless of whether it makes the
shift any faster or not.
Predator full negative "-25%" actually zeroes this table.
Never mind the math.
it at 0.150. My philospohy here is to get the shift
feeling solid but if it's good enough to suit then leave
it the slack. If you tell it zero it has to give full line
(PWM) on shifts regardless of whether it makes the
shift any faster or not.
Predator full negative "-25%" actually zeroes this table.
Never mind the math.
