4l80e swap programming?
FormerVendor
Joined: May 2004
Posts: 152
Likes: 0
Originally Posted by quicksilverado
HPtuners. 4l60e to a 4l80e.
Email me the full details of the vehicle and we can get you set up
Regards,
Ken
http://www.hptuners.com/
Originally Posted by Super Sport X2
Of course it an be done.
Email me the full details of the vehicle and we can get you set up
Regards,
Ken
http://www.hptuners.com/
Email me the full details of the vehicle and we can get you set up
Regards,
Ken
http://www.hptuners.com/
quick Q' off the topic a little. are the connectionsconnectors the same on the 4l80e and the 4l60e? i will be using HPT and have a file out of a truck an 4l60e. thanks and not trying to hi-jack your thread.
Nick
Nick
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
~ The wiring harness, and harness adapter from speartech. The main 4l60e harness plug will not work with the 4l80e. Speartech has and adapter the plugs into the 4l60e harness then plugs into the 4l80e. The other harness that comes with the kit it the VSS plug. The 4l80e has two VSS senors on the drivers side and the stock 4l60e only has one. You will have to connect this to the actual PCM its self. then plug the new added harness into the FRONT VSS. If you plug it in the rear you are going to have idle problems. (been there done that, lol)
Yeah, there's a great writeup/sticky in the Automatic Transmission forum that details everything needed, it was really helpful when I did my '80 swap.
...and yeah, HPT makes the swap easy and has great customer service to boot !!
Cheers,
Rob (Bad30th)
...and yeah, HPT makes the swap easy and has great customer service to boot !!
Cheers,
Rob (Bad30th)
Teching In
Joined: Jul 2007
Posts: 1
Likes: 0
I am having problems with that conversion. After everything was installed and programmed I am getting a transmission hot as soon as that happens it raises tranny line pressure and shifting gets horrible. We scanned it and tranny fluid temps are below 180C, changed the harness that reads the tranny temps (it was leaking) and still.
any help would really be appreciated going nuts with this thing.
any help would really be appreciated going nuts with this thing.
