timing at shift points
Thread Starter
TECH Enthusiast
Joined: Jan 2005
Posts: 658
Likes: 0
From: wisconsin
timing at shift points timing is dropping to -10 at shft points and when i first dump it to
the floor it will drop to -8 to -10 is that right, and im running 19
to 26 degrees timing thru the hole rpm range with about 2- 3 kr. thanks
the floor it will drop to -8 to -10 is that right, and im running 19
to 26 degrees timing thru the hole rpm range with about 2- 3 kr. thanks
TECH Enthusiast
Joined: Feb 2003
Posts: 614
Likes: 0
From: Michigan (Holland/Grand Rapids)
Sounds like Tourque Management is kicking in. What all did you tune with your HP Tuners? Did you try to disable Torque Management with the software? Maybe a paramter did not get turned off?
