Switching to a 2 bar Map Sensor?
02-01-2006, 07:53 PM
#1
On The Tree
Thread Starter
iTrader: (7)
Join Date: Jun 2005
Location: Sumter, S.C.
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
Switching to a 2 bar Map Sensor? I just put a 2 bar Map Sensor on my turbo'd '98 Camaro to control my progressive meth controller.
Do I need to change anything in my tune to make up for the 2 bar map sensor or will the computer figure it out?
Or is the stock Map a 2 bar?
Do I need to change anything in my tune to make up for the 2 bar map sensor or will the computer figure it out?
Or is the stock Map a 2 bar?
02-01-2006, 09:54 PM
#2
TECH Enthusiast
iTrader: (1)
Join Date: Sep 2004
Location: West Palm Beach, FL
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
The car probably won't run. I installed my 2 bar map, and tried to get the car started before changing over the operating system to a 2 bar. The car would start, but wouldn't idle. Do you have some kind of tuning software?
02-02-2006, 10:26 AM
#4
TECH Addict
you replaced your stock map with the 2 bar to make your meth work????
why the heck did you do that?
you just add the 2 bar externally to control the meth system. There is a little voltage drop box to get for it and you just wire up power and ground and hook a vacum source up to it.
why the heck did you do that?
you just add the 2 bar externally to control the meth system. There is a little voltage drop box to get for it and you just wire up power and ground and hook a vacum source up to it.
02-02-2006, 11:33 AM
#5
On The Tree
Thread Starter
iTrader: (7)
Join Date: Jun 2005
Location: Sumter, S.C.
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
That is a damn good idea. I am going to do that. My controller has the 5V output to power the map, so all I have to do is run a ground and run it in my boost line.
