I have a wiring harnes for a 98 A4 Z-28 and i know someone that wants it but his car is a M6 will it work?

 

I think it will. I would double check to be sure. I think you can't use a manual on an auto becuase there is no automatic tranny connectors.

 

Yes it will work. You have to move some a pin or two if you want the skip shift to work. But most bypass it anyways. He'll have to tune the code for it out of the pcm if you do not want to go through the trouble of repinning it. But while it's out it's a piece of cake to pull the loom and tape off and pull the auto wiring out up to the pcm. It would not take more than a couple of hours.

 

What about all the plugs for the 6 speed, the auto harness doesnt have them does it? I know the auto has the big round connector vs the 6 speed having the 3 or 4 smaller connectors.

 

What about all the plugs for the 6 speed, the auto harness doesnt have them does it? I know the auto has the big round connector vs the 6 speed having the 3 or 4 smaller connectors.

 

That's why you repin it if you want to keep the functions the pcm does like reverse inhibit, skip shift. But you do not need that crap to make it function. Plug in the vss ziptie back the auto connector reflash the pcm and save yourself the work and headache of screwing with it.

 

I thought the VSS was in the round plug. The vss is the only thing I care about working.

 

Naw the vss is the separate two pin plug with a purple, green black wire or yellow and purple. Good luck.