MANOFSTEEL69

Looked at it sitting in the garage, looked out at the snow, and wished it would go away, lol!

MR_M

iTrader: (5)

Ocala93TA

Love the look of your car! Sport gold metallic, where do i apply?? Lol

ta-stanger

iTrader: (6)

It was like 60 here today!! Snow still on the ground in spots! I had to go get her out of storage and go for a little drive through town just to remind the stangs that there *** is still mine! :> Only one thing better then that rumble under ur junk!

j99fbody

iTrader: (1)

it was mid 60s today so i got out their and got some sanding and body work done on it

Swiat34

iTrader: (9)

Update from yesterday: Got the rear end in my Trans Am. Sucks that it has 2.73s in it but at least I can drive now! Took it out for a quick test drive and I still EASILY spin my 325/30R19 Eagle F1SC EMTs. SMH. And I figured with those wide tires I'd be hooking and flying. Oh, and did the heater hose mod on the rear coils while I was at it!

ANTICOP RAM AIR

iTrader: (7)

Changed my oil 5/30 full synthetic raised my oil pressure considerably. Back up to 70psi at WOT

bmiller0608

Changed the oil, and replaced the headlight motor gear.

lncboytre_d

Removed the brake booster and the a/c hose assembly......then fired her up for about ten minutes...smiled and gave a long sigh

l 95 Trans Am l

iTrader: (5)

Raced an 88 Monte Carlo SS (LOL), filled her up with Ethanol free 93 Octane, and put the car cover on it because its gonna snow tonight

Shane

All I did today was drive it.

bmiller0608

Installed DDM slim HID 6000k for the fog lights. Can't wait till I get the housings from LMC to do the low beams.

Suzaku

iTrader: (3)

Put in new rear rotors and pads in my trans am.

Fixed the brake squeal and the weak E-brake.

ANTICOP RAM AIR

iTrader: (7)

ordered new red leather and carpet from classic industries.. they have a 20% off code till the 5th of Feb.. saved me over $150

WBO2011

Suzaku

iTrader: (3)

Finished my Oil Cap Breather install by capping off the throttle body hose.

Blackhawk777

Fiberglass repair to the trans am hatch, and pulled a few dents from the quarters.... ALMOST ready for paint.

tuske427

iTrader: (1)

stil building it. will still be building it for some time. Today I worked on welding in my modified trans tunnel more, and slicing open what's left of the original one to blend it in. This will give me more room for a drive shaft safety loop and overall clearance.

stimpy

iTrader: (1)

openned the door of the unit and crawled over it to get some parts i am selling then closed the door waiting till spring so I can start on it .

bearcatt

iTrader: (41)

.



Thought about buying a Vette and selling my Firebird.


.

Suzaku

iTrader: (3)

Blasphemy!

Though if you were getting a C3 or a C2 vette, I wouldn't mind.

bearcatt

iTrader: (41)

Haha ! Sorry it would be a C5, C5Z or C6.

Two reasons why I might not buy a Vette.

1.) I've done so much work with upgrades on my Firebird, I would
have to start all over with a Vette to get it how I want it.

2.) Clutch changes are a bitch on a Vette.


.