When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
looking for an oil cap for valve cover with two tabs
Anybody know of a cap that attaches directly to the valve cover with 2 tabs? I removed the extended filler neck and just now learned that the valve cover has 2 tabs, but the original cap only has one slot for one tab.
Anybody know of a cap that attaches directly to the valve cover with 2 tabs? I removed the extended filler neck and just now learned that the valve cover has 2 tabs, but the original cap only has one slot for one tab.
Also looking for the same two tab filler next part number for my 2011 L94
I'll have a look at my old LS3 covers and see if there is something I can find. Could you post a picture of what you need?
I ended up making my own oil cap out of a vent cap. Shaved it, cut the rubber to fit, sealed it, and added fittings for a vacuum blowoff valve and vacuum line for my vacuum pump.
This doesn't sound like an over complicated thing if you end up having to make something. Grommets go a long way here.
My LS1 with 241's originally had the single tab. The 10-14 Camaros and Vettes and the 09 or so G8's with the LS3/L99 use the 2-tab from what I had to research. I am sure there were more engines that used the 2-tab but I have never seen it until I got 799's for my build
the one I ordered (#12609623) fit right in there. I will verify that it is the one I used when I get home today because I did order another one from rock auto that didn't fit.
My LS1 with 241's originally had the single tab. The 10-14 Camaros and Vettes and the 09 or so G8's with the LS3/L99 use the 2-tab from what I had to research. I am sure there were more engines that used the 2-tab but I have never seen it until I got 799's for my build
gotcha, edited that, ive only seen the SINGLE tab versions. I havent worked on much gen4 stuff
I have a 2011 6.0 ltr with a two tab valve cover. I didn't want to grind off the tab on the valve cover so I used a couple different dremel bits and ground the cap to accept the second tab.
Before my dremel attached the cap After a little grinding. Fits snug. I'll have to wait and see how well it seals.