My Budget BBC 4th Gen Project
#86
its out of a 2004 3/4 ton truck... has 16,000 miles on it... has everything on it except harness and throttle body... it was out of my buddies truck... the motor was under waranty and he works for the dealer and bought this motor back and i bought it off of him for 500... he got it replaced cause he said it had a tick in the bottom end... so i dont know anything about it... someone make me a deal on it and ill post some pics tomorrow...
would rather trade...
thanks ed... sorry for thread hogging
would rather trade...
thanks ed... sorry for thread hogging
#87
Any progress here?
I'm taking a crash course in 8.1 swap 101...and learning much.
I'm running a late 8.1 dbw in a 69 Vette attached to a Richomd six....and hopefully side pipe headers.
Using a modified Painless harness for a LQ DBW - running into some minor headaches on knock sensors...and wire connector for the ECT.
My oil pan is at the fabricators getting shortened...and I also ran medium duty truck mounts like you did on your truck to clear the a/c on my X member.
I'm taking a crash course in 8.1 swap 101...and learning much.
I'm running a late 8.1 dbw in a 69 Vette attached to a Richomd six....and hopefully side pipe headers.
Using a modified Painless harness for a LQ DBW - running into some minor headaches on knock sensors...and wire connector for the ECT.
My oil pan is at the fabricators getting shortened...and I also ran medium duty truck mounts like you did on your truck to clear the a/c on my X member.
#89
its out of a 2004 3/4 ton truck... has 16,000 miles on it... has everything on it except harness and throttle body... it was out of my buddies truck... the motor was under waranty and he works for the dealer and bought this motor back and i bought it off of him for 500... he got it replaced cause he said it had a tick in the bottom end... so i dont know anything about it... someone make me a deal on it and ill post some pics tomorrow...
would rather trade...
thanks ed... sorry for thread hogging
would rather trade...
thanks ed... sorry for thread hogging
#90
Any progress here?
I'm taking a crash course in 8.1 swap 101...and learning much.
I'm running a late 8.1 dbw in a 69 Vette attached to a Richomd six....and hopefully side pipe headers.
Using a modified Painless harness for a LQ DBW - running into some minor headaches on knock sensors...and wire connector for the ECT.
My oil pan is at the fabricators getting shortened...and I also ran medium duty truck mounts like you did on your truck to clear the a/c on my X member.
I'm taking a crash course in 8.1 swap 101...and learning much.
I'm running a late 8.1 dbw in a 69 Vette attached to a Richomd six....and hopefully side pipe headers.
Using a modified Painless harness for a LQ DBW - running into some minor headaches on knock sensors...and wire connector for the ECT.
My oil pan is at the fabricators getting shortened...and I also ran medium duty truck mounts like you did on your truck to clear the a/c on my X member.
#93