dz2a8r

Well it was going great, two (what appeared to be 600s or so) on I-30 riding side by side with me behind them. One of them motioned to the other to go
and when they did all hell broke loose. I opened it up and pulled into the center lane to get around them. Got right to the rear tires and about 135mph
POP!! Fileld the interstate with white smoke and limped it on down to 65th st of all places HEHE. That sucks. Anyhow, does anyone know why I keep breaking tailshaft housings. Managed to find one in Jacksonville at Quality Trans for a good price.

Also gotta a hella deal on a car hauler trailer about 6 yrs old, wood floor, ramps, straps,new tires, and a Snap-On road box with a few craftsman tools inside.
Asking $1500 for everything, will sell just the trailer without the box for 1000

send me a MSG if interested

go ahead and post if you have any ideas with the tailshaft housing!

99Hawk262

iTrader: (19)

Steel driveshaft? They don't like the high speeds....Bene broke his a couple months back on a high speed run. If you have a steel one, that's my guess. Get an aluminum one and call it a day.

99Hawk262

iTrader: (19)

https://ls1tech.com/forums/lsx-parts-sale/793103-pro5-0-shifter-ls1-driveshaft-more.html

This guy is selling one if you need one. $175 shipped.

02402RAMAIR

iTrader: (8)

I have a drive shaft

$175.00 you pick up

the_merv

iTrader: (88)

Those Aluminum Drive Shafts are good stuff..

As far as the Tail Shaft Housing goes..

Tunnel Brace Mounted Torque Arm F.T.W.!!!

99Hawk262

iTrader: (19)

That's definitely on my to-do list. Probably this spring.

dz2a8r

Got the tailshaft housing in. Up and running again. Will probably be investing in a alum. driveshaft and an adj TRQ arm sometime in the next few cold months. I'll get in touch with you Kelt when I get ready to spen the money and see if you still have it.

bene

iTrader: (16)

Niiice. I mean welcome to the club. One of my things to do list for my car... Alum DS, TA on tunnel brace mounted but of course it have to fit w/ my true duals.

Rhino79

iTrader: (7)

Yep the steel ones don't like it as much, and it could very well be out of balance. I 'd just get that aluminum one from Keltner.

the_merv

iTrader: (88)

Good luck with that bro..do yours come together and run side-by side right after the Tranny, I don't remember..

bene

iTrader: (16)

To be honest, I can't remember either. I'll take some pictures after I change my oil this weekend.

the_merv

iTrader: (88)

That will help you figure it out..compare them with mine and see if you will have some clearance. It may be a tight fit..