Fivepointseven Tick performance used to have a deal installed and tuned on their website

 

thanks, checked their site but didnt see anything

 

Yeah they just updated the site, you can call em or pm Joey. You could try pming a few guys in here to.

 

Track was fun today, even though my best time was a 13.06 my first at 110. 2.5 60's suck.

 

i would think you should be trapping higher than that though......definately need to work on that 60' though.......i was considering going today myself but since i've been busy all week with my car i decided to just chill today.....i'll probably go next friday though.....i really wanted to get my 3.73's put in before i hit the track but for some reason they couldn't change the pcm settings for them....so i've got to figure that out.....

 

I wish you would have went man I only ran a 3.80 at 105 with a 2.2 60' but I still got a lot to learn, that was my first time

 

Keep in my I'm a Gto, my car weighs 3750 with me in it and a 6 speed car, its a bit harder for me at the short end.

 

Lmk the next trip. Got my goat 2 months ago and though it has exhaust only Id love to see how it runs.

 

Mines exhaust and headers only with stock tune and I couldn't break 13.8 but friday if the tracks open for test and tune ill be there

 

It felt nice driven the Blue Bitch around today... I will be driven around post tomorrow again during the work day

 

Transmission and stall went in without too much fuss. I parked the 'bird until Wednesday because I got a little concerned about the fluid temp. I bypassed the factory tranny cooler and used the one that came with the transmission. Temps got up to the 190 area. So I ordered a B&m stacked plate cooler. Apparently there are two schools of thought on if you should just rely on the external cooler, or run both the stock and external. So I am considering running both and see how that goes..

 

this is some of the stuff that is inside of the Blue Bitch

 

I have my tranny fluid going from my radiator and then external cooler that I have on the front of my radiator and then back to the tranny. I'm not sure what the temp on the tranny fluid is running at, I need to hook up a gauge

 

That's likely the way ill have it and leave it. Gotten more than one message telling me to do it that way, lol.


And I never got to see uyour "blue bitch" wein, but I wish I had. I've never run anything but chains on my gen 1 blocks, are the geared setup as noisy as they say?

 

hey wein....i saw you drive through our parking lot on kelley hill yesterday....lol.....so who's taking your spot for reenlistment....i have some questions....

 

Yeah it'd be nice to have you out, I'm going to see if I can get a few more GTO guys I know that aren't on this forum to roll out with us. What all do you have done to it?? Also on a side note its nice to see this thread getting back to productivity, everyone's getting along

 

I know the noisy gear drives are pretty loud. Never heard the quiet ones. Wein, can you post an idle vid? Maybe a vid of you taking off or accelerating? Goose, your on the right track with the cooler. When I did my swap I used the big b&m cooler with a fan.

 

I thought you worked on main post?

 

wein works/worked on main post in splinter village.

 

Some of the Counselors are fighting for my position.... Yes I work at Soldier Plaza, but I drive to the different Units to check on some of the Soldiers, I have to take a break from my office throughout the day

I dont think my timing gears are that noisy.. lol I can post a vid of it, I will see what I can do