Little far but not too bad!



3 DEPOSITS PAID SO FAR THIS WEEK.

GOT A COUPLE PHONE CALLS TO RETURN AND THAT SHOULD ADD ANOTHER COUPLE TO THE LIST.

-Jaosn

 

Call me!

 

Up to 5 deposits already.

 

If they will 1st gens, and 1 3/4 I'm in!! Whts the size going to be, 1 3/4 or 1 7/8? I dont see how 7/8 will fit..but ya never know! will they be for 6 speeds or auto?

 

We are going to try our best for 1 7/8"

They will be designed for a second gen, but I am told its possible the same header could work on a 1st gen. No guarantee though

Since it will be just headers and not a full exhaust with crossover, we can make allowances so they will work with both.

-Jason

 

Hope everyone had a good weekend. Let's keep this rolling on!

Really surprised that i sent PM's to 16ish people and only have 5 deposits in so far! CHECK YOUR PM's!

 

Just sent out PM's to everyone who expressed interest but has not yet contacted me.

-Jason

 

Damn.. I'm very tempted.. an 1 7/8" stainless is exactly what I'm looking for. I'll throw in a deposit if you can wait til the first of the year. I think Christmas time probably wasn't the best time to try this.

 

Didn't even connect those dots. Good point.

-Jason

 

Pm sent

 

Sorry for the delay but will make a deposit just shoot me some info back in the PM I sent. Thanks

 

That was what I was saying. I certainly can't till after 1st of the year. Sorry.

 

Got a couple more PM's back. Expecting to add another couple guys to the list by the end of the week.

Things are still moving!

-Jason

 

Any idea on approx. how long before headers will be ready for purchase once you have enough deposits?

 

Once we start working, we ought to have a product in 4-6 weeks.

 

I would love a set but I need them to not only fit a 1st gen but also a blazer...

 

Christmas Eve bump, I want my headers!

 

I want a set. Where do I send the $150 deposit, and in my case it's going on a 2wd 1999 S10 Blazer 4 dr.
Just want to let you know that on 4 door 2wd blazers the engine mounts have a 1 inch or 1 1/2 perch from factory. I'm thinking this should give me more room for the 1 7/8 clearance.
Even if I have to hit the floor up a little or bend the seem I have no problem...

 

I wish these were available when I built my 03. Had to run the junk sanderson shorty's.

 

I am swapping an LS into my Syclone and would love to see what would work. I am looking for a drivers side 1st gen and a universal turbo manufold for the passenger side with a flange for a pt88. This will probably be the same/similar that many other 1st gen people are looking for. Anyone else?