timmkish

iTrader: (16)

OK, so the new HU is connected and I'm all set to mount it in my dash(02 Pont WS6) Got the dash kit and all that, but what do I screw the bracket on the back of my HU to, to keep it from sliding around? Any mounting advice would be appreciated!

jimmy 2 Times

iTrader: (18)

back strapping is not needed, it will not slide around

timmkish

iTrader: (16)

how can you say that? everytime i accelerate, it almost flies out and lands in my lap

Luna

iTrader: (6)

uhh then you didnt do something right.... did you use the little metal surround that snaps into the plastic pretty snugly?

jimmy 2 Times

iTrader: (18)

if that is the case, then you obviously have done something wrong, post a pic of your set up.......i would love to see what you have done


btw, i have had about 10 differnet decks in my camaro since i bought it in 01....i have never had one "slide around" or land in my lap

Phoenix 5.7

iTrader: (7)

the tabs on the metal slidin thing on the HU need to be bent up snugly against the dash kit.

timmkish

iTrader: (16)

problem solved(at least i think) the HU was an open box buy. myer emco neglected to include the sleeve that gets attached to the dash kit. a quick call and a trip tomorrow to pick up the missing piece should take care of it.

joe_kool315

OH yea that's definatly the problem ... that'll cause her to slide right out into the floor board if you take off ... like I do the sleave is what holds it in place