What have you done to your car recently?
07-14-2011, 05:41 PM
#82
Staging Lane
iTrader: (14)
Join Date: Oct 2007
Location: Charlotte, NC
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
FINALLY got the spray working. We had to back it down to a 150 shot because fuel support. I have a Walbro but ill be going with a standalone and C16 soon and trying a 200, possibly 250. I have a spare motor so why not.
http://www.youtube.com/watch?nomobile=1&v=LQUMFPaBtGA
http://www.youtube.com/watch?nomobile=1&v=LQUMFPaBtGA
Last edited by kilgothephenom; 07-14-2011 at 05:52 PM.
07-17-2011, 06:52 PM
#83
TECH Enthusiast
got the block back from R&R yesterday. shortblock is assembled. everything was perfect tolerances.
I have to recommend them of you are near Huntsville Al.
I have to recommend them of you are near Huntsville Al.
07-17-2011, 07:14 PM
#84
TECH Enthusiast
that engine stand is an old one. a 69 pontiac 400 ram air was the first motor ever built on it...in ~1991.
Last edited by assasinator; 07-17-2011 at 07:22 PM.
07-17-2011, 08:13 PM
#85
I just removed the air/egr, gonna throw on the pacesetter lt's/y pipe and dynomax muffler with a dump on it this week along with soem lca's and an adjustable phb and some dr's, shootin' for solid 12's!
07-31-2011, 06:39 PM
#86
TECH Enthusiast
soldiering on in this heat. heads are installed, timed, and timing chain cover on, water pump on.
gonna fabricate mount for turbo next week.
didnt touch the heads, they are already ported and have low miles. just took them off and put them back on. water pump is the same one it already had. rebuild is just for more overall strength.
gonna fabricate mount for turbo next week.
didnt touch the heads, they are already ported and have low miles. just took them off and put them back on. water pump is the same one it already had. rebuild is just for more overall strength.
08-11-2011, 12:32 AM
#91
Staging Lane
Join Date: Nov 2008
Location: Riverside, CA 92506
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Put UMI strut tower brace on, LS1 Ported throttle body, plan on putting NGK plugs in and a 160 thermostat. thats if i can figure our if its my battery, starter, or alternator thats just crapped out on my car 
08-11-2011, 01:26 AM
#92
On The Tree
Join Date: Aug 2009
Location: Wilmywood NC
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Just about ready to crank; have to prime the oil pump and change two rocker shafts that I accidentally broke spinning the motor over on the engine stand.
Last edited by Heater; 08-11-2011 at 01:55 AM.
