Paxton vs On3 vs TVS Cobro
#1
Teching In
Thread Starter
Paxton vs On3 vs TVS Cobro
Went to NMRA and these are a few runs that happened. Mr. LSX is the owner of the Paxton car, and he will have even more footage soon from this weekend.
Paxton: 2200, 10psi wastegated, exhaust, 4C stall, E85, Lund tune
On3: On3 kit, T56 mag, 11 psi, Sai Li tuned on E85
50 Roll:
40 Roll Paxton car got the hit
5.0: On3 kit, T56 mag, 14-15psi, E85
Cobra: TVS, 100 shot, E85, Solid rear swap
5.0 came around him when he passed by Mr. LSX and I.
Was a fun weekend and was nice meeting everyone again. Mr. LSX's car is a hammer for sure, and runs damn hard!
Paxton: 2200, 10psi wastegated, exhaust, 4C stall, E85, Lund tune
On3: On3 kit, T56 mag, 11 psi, Sai Li tuned on E85
50 Roll:
40 Roll Paxton car got the hit
5.0: On3 kit, T56 mag, 14-15psi, E85
Cobra: TVS, 100 shot, E85, Solid rear swap
5.0 came around him when he passed by Mr. LSX and I.
Was a fun weekend and was nice meeting everyone again. Mr. LSX's car is a hammer for sure, and runs damn hard!
Last edited by Its Stock; 10-05-2015 at 09:52 PM.
#3
Teching In
Thread Starter
Indeed it was, that car ran very hard. The TVS and Paxton car ran as well but the Cobra was spinning some on their run. I'll let him post the results later.
Trending Topics
#9
Teching In
Thread Starter
#18
On The Tree
#20
Teching In
Thread Starter
Why would I? Too expensive when I can get the 6R80, Exedy clutches AND a stall for like half of how much it'd cost me for the T56 mag. I will miss shifting a lot, but I might be able to have that fix covered pretty easily.
Alright Han Brolo, calm down now.
Alright Han Brolo, calm down now.