When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Those cars seem to be very impressive, and with the titanium rods I wonder how much the sbe can take. I guess I'm just surprised I don't see more or hear about them at all.
My dads new car is done. Just wait for the shipping company. Made 466 whp, 2400 lbs.
Badass car
Originally Posted by WisT02ws6
Those cars seem to be very impressive, and with the titanium rods I wonder how much the sbe can take. I guess I'm just surprised I don't see more or hear about them at all.
A few are around 750 wheel the motors seem very stout . Most guys don’t drag race the car more worried about street races or going around corners lol .
What kind of compression could I run with ls3 heads? I would be taking off the prc 2.5 5.3 heads on a ls2 403, It has flat top pistons with valve reliefs. I keep hearing about bad ptv clearances with this swap, what do you guys know?
What kind of compression could I run with ls3 heads? I would be taking off the prc 2.5 5.3 heads on a ls2 403, It has flat top pistons with valve reliefs. I keep hearing about bad ptv clearances with this swap, what do you guys know?
Post in the "Generation IV" section for much better technical question results.
What kind of compression could I run with ls3 heads? I would be taking off the prc 2.5 5.3 heads on a ls2 403, It has flat top pistons with valve reliefs. I keep hearing about bad ptv clearances with this swap, what do you guys know?
i would imagine you could get to 11.5 to 12:1 with milling. With valve reliefs you should have alot of room.
Idk what all your mods are or what the car is like. But you would probably be better off spending the $ elsewhere.
12-20-2020, 10:58 AM
