slow ride 02

For anyone wanting to use these calipers and 17" SS 10 spokes. Its not going work! Only because the SS 10 spokes have this 1/4 lip (see photos) the off-set was very close, little to no spacer would have been needed. It looks like there are some 18"/19" C6 ZR1 wheels in my future!

JJsQwuik

iTrader: (17)

My SS/ZR1 have the same lip but not that deep into the wheel. It's more of 1/4" after the spokes and all I had to do is grind down on the calipers to fit. Have you tried using any spacers?

slow ride 02

I am going to mock it up tomorrow to see how much of a spacer would be needed, but it looks like well over an inch would be needed. That lip is almost 2 1/2 inches from the spokes. Without that lip there would be very little grinding needed and a 1/4 spacer at the most.

Ballzee

iTrader: (5)

if you're rocking those good looking brakes you need to ditch the 10 spokes anyways...lol

slow ride 02

It would have taken a 1 1/2 spacer. And I would have had no problem running that thick of a spacer, as they are availble. But the tires would have stuck out past the fender! and thats no bueno!

slow ride 02

What size wheels and tires are you running on that bad boy of yours?