Anyone have a wheel off right now??? Need a measurement! HELP!
#1
TECH Resident
Thread Starter
iTrader: (1)
Join Date: Jan 2005
Location: Indy
Posts: 873
Likes: 0
Received 0 Likes
on
0 Posts
Anyone have a wheel off right now??? Need a measurement! HELP!
Need that number. After the bent K-member we still have one or both spindles/knuckels whatever they are actually called out of spec. Both have a different measurement and they are 1/4" off each other. I THINK 1 was 8 1/8" and the other was around 7 3/4"-7 7/8" No stress marks from flex so its making it difficult to figure which is bent. Those inches may be way off but I'll see the car tomorrow to get my exact. Just need someone to measure that!
Thanks in advance!!!!!
Brandon
Drawing NOT to sale by anymeans.
#4
TECH Resident
Thread Starter
iTrader: (1)
Join Date: Jan 2005
Location: Indy
Posts: 873
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Beast96Z
You owe me one. I just went outside in my underwear with a level and a tape measure at midnight 30. Anyway, Mine show to be somewhere around 7 7/8" to 8". It's hard to get a exact measurment, but this is very close.
You are THE MAN!!! Thanks a ton.. I really really appreciate it! Glad you knew what I was talking about in the pic!!!
Thanks again!
Brandon
#6
TECH Resident
Thread Starter
iTrader: (1)
Join Date: Jan 2005
Location: Indy
Posts: 873
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by mitchntx
a 1/10 of an inch will yeild several degrees of camber. You need to get it on an alignment rack and do a caster sweep ....