Clunking noise after UMI TM adj TA install
04-23-2008, 07:31 PM
#1
TECH Resident
Thread Starter
iTrader: (20)
Join Date: Jun 2005
Location: Lansing,IL
Posts: 878
Likes: 0
Received 0 Likes
on
0 Posts
Clunking noise after UMI TM adj TA install I just got done installing my UMI Tunnel Mount Adj TA and went for a drive. Everytime I shift there is a clunking noise. I didn't get the pinion angle finder tool. what would be a suggestion to fix this?
04-23-2008, 08:16 PM
#3
TECH Resident
Thread Starter
iTrader: (20)
Join Date: Jun 2005
Location: Lansing,IL
Posts: 878
Likes: 0
Received 0 Likes
on
0 Posts
its good but i should change it out. I skimmed through the instructions a few minutes ago....... and yeah I should check all the bolts again 
It defintiely feels a whole lot better though 
It defintiely feels a whole lot better though 
04-27-2008, 03:56 PM
#5
TECH Fanatic
iTrader: (2)
Join Date: Jan 2007
Location: Ashland & Lexington, KY
Posts: 1,419
Likes: 0
Received 0 Likes
on
0 Posts
What kind of end does it have on it? 4130 or Poly?? I have 4130 (Spohn) and it clunks.. Just the end type.. I believe if I'd have gone poly then it wouldn't do it..
