Who is going to the San Antonio *meet*??
#4369
On The Tree
iTrader: (1)
Join Date: Feb 2007
Location: San Antonio TX
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
well yeah thats later on ill get them......i got a fuel pump with the hot wire kit also...bought some coil packs...gna look for some fuel rails but adolf gna sell his too get the fast rails so we'll see what happens...i need to get a better tune cuz my shift points r kinda fucked up they stick sometimes and doesnt shift
#4373
On The Tree
iTrader: (27)
Join Date: Dec 2008
Location: Middle of nowhere, Ny
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
well yeah thats later on ill get them......i got a fuel pump with the hot wire kit also...bought some coil packs...gna look for some fuel rails but adolf gna sell his too get the fast rails so we'll see what happens...i need to get a better tune cuz my shift points r kinda fucked up they stick sometimes and doesnt shift
hell they will handle what im gonna throw at my car with the bigger cubes.
I'd strongly suggest spending your money on the rod bolts and not the rails. cause even if you have new rails you can spray a motor with rod knock.
#4374
On The Tree
iTrader: (1)
Join Date: Feb 2007
Location: San Antonio TX
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
you dont need rails right now. stock rails will handle what your gonna throw at it just fine.
hell they will handle what im gonna throw at my car with the bigger cubes.
I'd strongly suggest spending your money on the rod bolts and not the rails. cause even if you have new rails you can spray a motor with rod knock.
hell they will handle what im gonna throw at my car with the bigger cubes.
I'd strongly suggest spending your money on the rod bolts and not the rails. cause even if you have new rails you can spray a motor with rod knock.
#4380
On The Tree
iTrader: (27)
Join Date: Dec 2008
Location: Middle of nowhere, Ny
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
its what....quit typing like lala.
anyways. I have a set of milled 243's. the pistons and rods are stock. just re did all the bearings and a set of mahle rings gapped for nitrous.
i should be at 11:1 - 11.5 :1 compression with the heads.
anyways. I have a set of milled 243's. the pistons and rods are stock. just re did all the bearings and a set of mahle rings gapped for nitrous.
i should be at 11:1 - 11.5 :1 compression with the heads.