2009 Escalade ESV Detail
#1
TECH Enthusiast
Thread Starter
iTrader: (6)
Join Date: Mar 2003
Location: Irving Tx 75060
Posts: 612
Likes: 0
Received 0 Likes
on
0 Posts
2009 Escalade ESV Detail
Received a call from a mutal friend to get this Escalade ESV cleaned up for his Boss. She bought this car sight unseen for a pretty good deal but when she saw it, it was covered in some bad swirls/marring. It took a good while but she was very pleased with the end result. This thing is HUGE.
Washed with Meguiars soap.
Spot clayed using clay magic.
First pass correction using Meguiars M105 / LCC orange pad.
A few panels were corrected using Menzerna SIP/ LCC orange pad
Followed by Meguiars M205 / LCC black pad.
Polished with SFX polish / LCC blue pad.
Sealed with SFX blazin maize / LCC blue pad.
Tires and trim dressed with SFX dressing.
Fender wells cleaned with APC then dressed with Meguiars natural finish.
Glass cleaned with Stoners crystal clear/microfiber.
Masked off ready for buffing:
Corrected:
Questions/Comments welcome
Washed with Meguiars soap.
Spot clayed using clay magic.
First pass correction using Meguiars M105 / LCC orange pad.
A few panels were corrected using Menzerna SIP/ LCC orange pad
Followed by Meguiars M205 / LCC black pad.
Polished with SFX polish / LCC blue pad.
Sealed with SFX blazin maize / LCC blue pad.
Tires and trim dressed with SFX dressing.
Fender wells cleaned with APC then dressed with Meguiars natural finish.
Glass cleaned with Stoners crystal clear/microfiber.
Masked off ready for buffing:
Corrected:
Questions/Comments welcome
#4
TECH Enthusiast
Thread Starter
iTrader: (6)
Join Date: Mar 2003
Location: Irving Tx 75060
Posts: 612
Likes: 0
Received 0 Likes
on
0 Posts
It's a stock Escalade ESV. Unfortunately, I finished this when the sun was already down and the outside light was minimal. That along with the garage I was working in was a bit cramped so I only was able to snap close ups.
#6
TECH Enthusiast
Thread Starter
iTrader: (6)
Join Date: Mar 2003
Location: Irving Tx 75060
Posts: 612
Likes: 0
Received 0 Likes
on
0 Posts
I was working around childrens toys/strollers etc. It wasn't a problem, but there was no area to stand back and take complete pics of it. It was huge.