WTB.. LS1 junk engine block
#1
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Dec 2004
Location: Kingwood, tx
Posts: 556
Likes: 0
Received 0 Likes
on
0 Posts
WTB.. LS1 junk engine block
I am wanting to make an Ls1 engine cofee table. I am looking for a junk enine block that will make a good coffee table once cleaned up. Preferably without a hole through the side.. Also i dont want a good one, I wont pay alot for it. Let me know your price.. Houston area as well. Thanks.
If you have 4 rods and pistons, that would also be a plus.
If you have 4 rods and pistons, that would also be a plus.
#3
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Dec 2004
Location: Kingwood, tx
Posts: 556
Likes: 0
Received 0 Likes
on
0 Posts
I'll think on it, but i really didnt want to spend that much. That's y i figured it would be better to ask for one that couldnt be repaired. If you will go lower let me know. Anyone else have one??
#4
TECH Junkie
iTrader: (12)
Join Date: Jul 2002
Location: Austin, TX
Posts: 3,422
Likes: 0
Received 0 Likes
on
0 Posts
You know you cant bolt the rod to the top right ? Is that how you plan to put the pistons ? I've already looked into this too but I'm going to use an ironblock ls1 you can get those for nothing.
#5
TECH Veteran
iTrader: (1)
Join Date: Nov 2001
Location: Houston,TX
Posts: 4,167
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by leeluther252
I am wanting to make an Ls1 engine cofee table. I am looking for a junk enine block that will make a good coffee table once cleaned up. Preferably without a hole through the side.. Also i dont want a good one, I wont pay alot for it. Let me know your price.. Houston area as well. Thanks.
If you have 4 rods and pistons, that would also be a plus.
If you have 4 rods and pistons, that would also be a plus.
I have a junk block that i will sell for $50...thats what i paid for it when i was using it for mock up purposes. I am located in Deer Park, shoot me a pm if you'd like to come check it out
Clint
#6
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Dec 2004
Location: Kingwood, tx
Posts: 556
Likes: 0
Received 0 Likes
on
0 Posts
table
Originally Posted by redaddiction
You know you cant bolt the rod to the top right ? Is that how you plan to put the pistons ? I've already looked into this too but I'm going to use an ironblock ls1 you can get those for nothing.
like this